Before................. After

Tonnolli Canada, Mississauga, Ontario

PROBLEM: The acids combined with very heavy abrasion in this crushing and acid collection room of this automobile battery recycling plant were causing extreme deterioration of the epoxy coated concrete floor and walls.

SOLUTION: JETSET was applied to the concrete surfaces after the epoxy was removed to provide a long-term surface that is resistant to the acids as well as able to withstand the constant heavy abrasion that the floor is subject to.

PROBLEM: Hot hydrochloric acid in these pickling lines was corroding the steel tanks despite a vulcanized rubber lining and three layers of acid brick.

SOLUTION: JETSET 727 Liner was applied directly over the acid brick providing a monolithic acid resistant surface. By removing the need to remove and replace the acid brick the job was completed in a fifth of the time from conventional techniques.

PROBLEM: Sulfuric acid corrosion had deteriorated the floor and machine bases in this acid production plant.

SOLUTION: JETSET was used to rebuild machine bases as well as overcoat the entire floor area to provide long-term protection in this harsh industrial environment.

PROBLEM: A heavy duty chemical resistant coating was required to protect the concrete and infrastructure as part of this secondary containment area.

SOLUTION: JESTET 735 Finish Coat was applied to the floor area as well as 8 inches up all bases within the containment area for long-term protection and aesthetic finish.

North Wentworth Hockey Arena, Flamborough, Ontario

PROBLEM: Excessive humidity from the ice surface was migrating through block walls and causing painted surfaces to blister and peel at these two arenas.

SOLUTION: EBM was applied to interior and exterior block walls eliminating bulk water migration while allowing the building to breathe. The EBM also provided an aesthetic finish that resists blistering and peeling.

PROBLEM: Normal weathering was causing the steel deck roof to corrode and leak..

SOLUTION: Rust spots were coated with 510A Aluminized Urethane to stop the corrosion. The entire surface was then coated with EBM to form a seamless elastomeric membrane that beautified, protected and waterproofed the structure.